Amcor PLDM 22E User Manual download pdf (Page 8)

When the water tank is full, the unit will switch off automatically and beep 15 times, t

he LED [1] on the control panel will light up. The tank needs to be emptied:

• Lightly press on the sides of the tank with both hands

and pull out gently.

• After discarding of the water, gently push the tank

back into its place. The LED light will go off.

Warning:

1. Do not remove the float from the water tank,

the Water full sensor will no longer be able to

detect the water level correctly without the float

and water may leak from the water tank.

2.If the drainage tank is dirty, wash it with cold or

lukewarm water. Do not use detergent, scouring pads,

chemically treated dust cloths, gasoline, benzene, thinner,

or other solvents, as these can scratch and damage the

tank and cause water leakage.

3. When replacing the drainage tank, press the tank

firmly into place with both hands. If the tank is

not positioned properly, the “TANK FULL” sensor

will be activated, and the dehumidifier will not operate.

For the continuous drainage please refer to the following instructions and picture.

1. Switch off the unit and remove the plug from the electrical outlet.

2. Cut out the hole (move part A) for the drainage tube on the tank.

3.Push a drain tube (14mm outer diamete r,

10mm inner diameter) through the hole,

and connect to the continuous drainage

port (part B).

4. Place the other end in a drain. Make sure the tube

is free from twists and bends/

NOTED:

The water tank has to remain in place, even

when using continuous drainage.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Amcor PLDM 22E User Manual Page 8